Heads that spray sideways, heads that will not pop up, heads that soak the sidewalk and miss the lawn. We repair and replace residential sprinkler heads across Mesa, Gilbert, Chandler, Tempe and the rest of the East Valley.
Call or text (480) 555-0100 — Mon–Fri, 8am–4pm.
A Phoenix-area lawn in July is living on a very thin margin. Bermuda grass in 110-degree heat is drinking hard every single day, and a sprinkler head that has stopped doing its job does not give you weeks of warning — it gives you a few days. That is why the call we get most often in Mesa is not “my sprinkler is broken.” It is “there is a dead spot in my lawn and I do not know why.”
Almost always, the dead spot is downstream of a head that is doing one of five things: not popping up, popping up but not rotating, spraying in the wrong direction, spraying a fine mist that evaporates before it lands, or leaking at the base so the zone loses the pressure that the far heads need. Sprinkler repair is the process of finding which one, and fixing the cause rather than turning the timer up and hoping.
We run each zone and watch it. That sounds obvious, and it is the step most often skipped. A zone has to be running for a bad arc, a plugged nozzle, a stuck rotor or a low-pressure symptom at the end of the line to show itself. Once the zone is up, we walk it head by head, check the throw distance and the overlap, and pull the heads that are not performing.
Then we fix the cause. That may mean a new head, a new nozzle sized to match the rest of the zone, a new riser or swing joint, resetting the head to grade, or re-aiming the arc so your water lands on grass instead of the block wall and the sidewalk. When a zone has a pressure problem rather than a head problem, we say so, because putting six new heads on a zone that cannot feed them is a waste of your money.
Most East Valley yards are a hybrid: turf on spray heads or rotors out front and back, and shrubs, trees and pots on a separate drip zone. They fail in completely different ways and they are diagnosed differently. If your problem is dry shrubs and damp gravel rather than a dead patch in the lawn, start at drip irrigation repair instead.
Three local conditions turn a minor sprinkler fault into a dead lawn quickly. Summer heat means a missed zone shows within days, not weeks. Hard Valley water means nozzles scale up and clog far faster here than in softer-water regions. And the overseeding cycle matters — when Bermuda goes dormant and a winter ryegrass overseed goes down in the fall, that new seed needs light, frequent, even water to germinate. A head with a bad arc in October does not just leave a dry spot; it leaves a bare stripe you look at all winter.
The flip side is that a repaired system saves real money here. In peak summer, irrigation is the majority of a Valley household's water use. A head leaking at the riser or a zone running twice as long to compensate for one dead head shows up on the bill every month until it is fixed.
The specific work behind the heading — all of it residential, all of it across Mesa and the East Valley.
Cracked, mown-off, stuck or sunken pop-ups swapped for matched heads set true to grade, with the nozzle and arc sized to the zone.
Rotors that have stopped turning, lost their arc setting or park in one place — rebuilt or replaced so the full sweep gets watered.
Scaled and grit-plugged nozzles and filter screens cleaned or replaced, and nozzles re-sized so heads on the same zone apply water at the same rate.
Snapped risers and cracked swing joints under the head repaired — the usual cause of a geyser or a patch of lawn that never dries out.
Heads re-aimed or relocated so water lands on turf instead of the sidewalk, the block wall or the neighbour's driveway.
A full run of every zone to find the dry corners, the overlaps and the mismatched heads that leave part of the lawn short.
Your reviews, carried onto every service page. [ Your Google and Yelp rating and review count appear here ] Placeholder — this demo does not display real review figures.
Four steps from your first call to water landing where it should.
Tell us what the yard is doing — a dead patch, a wet spot, a zone that will not come on. We will tell you on the phone what it most likely is.
Nothing gets quoted from a description. We run every zone, watch it, and find the actual fault instead of replacing parts and hoping.
You hear what is wrong and what it takes to put right, in plain language, before any work starts. No surprise additions.
Zones run again at the end so you can see the repair working, and the controller gets set up so you know what it is doing.
Sprinklers, drip, valves, timers, leaks and new installs — the whole irrigation system, not just the parts that are easy to reach.
We cover Mesa and the surrounding East Valley communities. Pick your city for what we see most often there.
What East Valley homeowners ask us about this work.
Still have a question? Call and ask — you get a real answer, not a script: (480) 555-0100
Straight diagnosis first. No pressure, no upsell.